Team Health & Safety - First Time Builder

[Al_]

I have used the 4mm bullet connectors to attach the drive motors to the ESCs on Pressure Point. They were liberally wrapped in heat shrink and had a bit of strain relief on either side of the cables (cable ties!). Despite been thrown around, and out of, the arena they have never given me any trouble.

https://hobbyking.com/en_us/4mm-gold...airs-20pc.html

[Zenith]

I have used the 4mm bullet connectors to attach the drive motors to the ESCs on Pressure Point. They were liberally wrapped in heat shrink and had a bit of strain relief on either side of the cables (cable ties!).

I imagine these connect two wires together? I'm at the point where the motor does not have any wires at all, but only the lugs visible at the back of this motor (these are in fact the very same motors I'm using).

Soldering these lugs seems risky to me, so it seems more sensible to hook the wires through, fold them backwards and then shrinkwrapping the folded wire around the lug.

Let me know what you think.