The gap in the middle should be there to allow you to tighten around the motor, so that should be ok,
The gap at the bottom, i guess was a height issue, perhaps if you let me know the height its missing i can make some spacers from some scrap for you to reach the base of those blocks.

Gotta go find the box of chocs now... fancy a strawberry choc

Hope your feeling better shortly,

+
Quote Originally Posted by Ocracoke View Post
Given I currently feel rather under the weather, I could really use some chocolate now.



I did. The face clamp works fine but I think I've screwed up on the 2 part design. They fit the can of the motor but on doing so don't quite meet each other in the middle, nor does the bottom sections reach the floor. I don't think this is a big deal and can be sorted, I wasn't quite expecting them to fit out of the box.

Either way though, thanks for making them! After Ant Freeze is done, I'll be working on Jibril so you'll see them go in.