New pinsor :)

[calumco]

been awhile since i've done anything pinsor related so heres the beginnings of pinsor 2 or pinsor evo or what not.finally made major progress with this, pic below

[attachment=1:27pbky8k]BILD0001.JPG[/attachment:27pbky8k]

[attachment=0:27pbky8k]BILD0002.JPG[/attachment:27pbky8k]

these were originally 2 robots, 1 would have been with all the claw and everything running off 4 drill motors, and the base of the robot was a 6 wheel drive hardox box, but after some thought i know i'd get bored of the box and a 6 wheel drive set up would go well with the claw etc so i combined the 2 robots

8kg at the minute, thats batteries, motors and weapon etc etc, just need to finish the drive timing pullys and get them on and then its litterally ready for a drive about etc

after i've added other odds and sods i'll have about 4kg left for the rest of the armour once its all wired up and everything wana try get some hardox on the front cause i really wana take it to spinner events so we'll see as for a srimech im not sure it'd be worth bothering, because it's gonna be slow to self right so im not sure if it'd be worth it so think ill opt for an extremly low ground clearance

so far its gone through 8mm hdpe like its not even there, poly etc etc even crushes computer towers easily 200kg actuator so im not too sure whats at the tip but its quite alot i've spent the last few hours distroying dvd players and sterios with it lol