drive

**harry hills** · 10th December 2011, 17:25

what motors?

**gizmo** · 10th December 2011, 17:32

18 volt drill motors

**harry hills** · 10th December 2011, 17:37

what like 1kg each?
i doubt that is the source of your weight problem

**gizmo** · 10th December 2011, 18:30

must of done my maths wrong I thought I only had 3kg spare but I actully have 6kg spare but I've just had a look how expencive the drills are and I can't afford another double set, however I may replace them with some cheaped drills. About 3 of the other drills cost as much as 1 of my drills.

**billy breach** · 6th January 2012, 00:20

has anyone used these?

http://www.ebay.co.uk/itm/4-x-125MM-5-D ... 4154871e76

if so how did you or how could you connect these to drill motors, you could put a 3/8 unf nut insert into the wheel, but how would you do this and get the nut to stay in the wheels without falling out?

**Anttazz** · 6th January 2012, 00:24

By heating the nut up and pressing it into the wheel, but those wheels might not be very grippy as they're made to last a long time rather than grip and wear down.

**Gabe01** · 6th January 2012, 12:54

Billy

You have just got some motors from Gimson, their wheels are really good, and cheap as well. I am very happy with their set up.

**billy breach** · 6th January 2012, 13:04

I have a set of the blue 100mm wheels that should be ok but was thinking of making some my self. Ill have a look at their website I never knew they done wheels. Cheers