help with Gianitcod 2.4ghz 4-Channel Mode2 Transmitter neede

[harry hills]

no its 2.4ghz

[woody]

No crystals needed.

Your pics are a little blurred and I cannot see a receiver power supply / 4.8v battery pack or BEC.

The Electronize FR15HVR and FR15TVR have a battery eliminator circuit (B.E.C.) providing a regulated 5 volt supply for the receiver and servo's... I don't think that the FR30HX has.


This possible lack of a 4.8v power supply to your receiver and thus your ESC's ( the internal electronics of the Electronize requires 4.8v / 5v to function and the internal electronics turns the higher voltage battery supply to the motor on and off ) and would explain your prob.

http://www.howesmodels.co.uk/Railways/v ... bCatID=132


BEC ...one of many makes... http://www.dimensionengineering.com/Par ... 4Qod_CNBIQ

Cheers Woody

http://www.dimensionengineering.com/BECFAQ.htm

[mattsdragons]

i am using 1 FR15HX and one FR15HVR so (as far as i was told) the addition of a 4.8v battery is not needed

[woody]

OK
Can you tell us what you has been done with the twisted orange and red wires from the FR15HVR.

[mattsdragons]

its currently not in use but is still connected because tbh, im not too sure what too do with it

[woody]

NP

Here's a pic ...

NOTE :- I've shown the signal wire in yellow in your case it is WHITE[attachment=0:2r42jcgu]FR15HX.JPG[/attachment:2r42jcgu]


Quick edit to pic....

[woody]

Make any sense Matt?

[mattsdragons]

how can i use 2 batteries for this?

my design uses 2

[woody]

how can i use 2 batteries for this?

my design uses 2

I've got an awful feeling that you might want to use one bat per controller.

My advice is DON'T ...simply wire up your bats in parallel[attachment=1:24ki7vmk]FR15HX2.JPG[/attachment:24ki7vmk]

Series config ...double the voltage.

[attachment=0:24ki7vmk]FR15HXseries.JPG[/attachment:24ki7vmk]

[mattsdragons]

i have connected it up in the first diagram way but im still getting nothing.

i know its a big ask but is anyone im the leicester area willing too let me bring my bot round so i can get someone wih more knowledge than me too have a look?