help with Gianitcod 2.4ghz 4-Channel Mode2 Transmitter neede

[mattsdragons]

i tryed too connect uo my Gianitcod 2.4ghz 4-Channel Mode2 Transmitter but its really not working right. there is power going too it (the green light is on) and when you press in the power lead from the esc's too the reciever, the wheels move for a second or so and then nothing, i cant control it from the transmitter.

if anyone has any experience with these help would be very appreciated

matt

http://www.giantcod.co.uk/gianitcod-24g ... 03779.html

[Anttazz]

Have you done all the binding process?

[mattsdragons]

forgive me, im shattered. what do you mean by binding?

[Anttazz]

Not a problem mate, You have to bind the transmitter and receiver to allow it to receive signals from the correct controller. There should be something in the instructions about it, but i'll have a look on that website you posted and see if I can tell you how.

When I had a wee look earlier I think I saw something about a rectangular hole on one of the small sides of the receiver?

[mattsdragons]

ye, there is.

i pressed the button and then nothing seemed too change

[Anttazz]

Found this on that website, hope it helps.

The bind procedure is the easiest, quickest, no fuss seen to date, this is done by powering up the transmitter and receiver, then a tiny button positioned at the end of the receiver case is pressed once. A green LED flashes for a second or so then stops, that€™s it, job done!

[Anttazz]

Was the transmitter on when you pressed it? Maybe thats the problem?

[jonny]

it is possible that it is a broken receiver or transmitter. i have had many problems with these transmitters and receivers.

[mattsdragons]

so it has 7 labled channels, and 2 connectors from the esc's. in which channel do i need the esc'c too go in?

[mattsdragons]

i ordered the Gianitcod 2.4ghz 4-Channel Mode2 Transmitter but what i think i have recieved is the radiolink t4eu and a r6eh but what i ordered was the t4u and the r6eh.