Wiring Electronize speed controler

[kronicstorm]

i am not sure ho to wire my Electronize speed controler up to me motors, could some one help me?.

I have wired it up once but it only goes forward and back.

[joey_picus]

I think theyre supposed to go forwards and back, if youre using Electronizes youll need one for each side of the drive for steering...

Could be misinterpreting your problem though.

[kronicstorm]

i have 2 Electronizes one for each motor but i dont know how to wire them all up Correctly.

[kodster]

You could PM Geoff, Woody, or Jonno if you need an immediate answer.

[widow_twanky]

If you can give a model number it would be good as there are a few different types (internal/external relays etc.)

Andy

[kronicstorm]

I am using 2 Electronize FR15HVR Microprocessor speed control.

[psycho_fling]

right wire the blue wire from one of the elctronize to the postive on one motor and then yellow to negative

do this for the other motor

you then need a mixer unless you are using a spektrum, i think this will solve the problem

link for a mixer i happen to have a used one if you need it

http://www.technobots.co.uk/acatalog/Online_Catalogue_RC_Input_Mixers___Interfaces_258. htmlhttp://www.technobots.co.uk/acatalog...ers___Interfac es_258.html

top product

if you already have one either switched on on the spectrum or one like above then im not sure

hope it helps, alex

[psycho_fling]

forgot to say you will need to plug the reciver wires into the reciver and put power to the circuit

what motors are you using?

[kronicstorm]

Would i need a
RC speed control Microprocessor 15A
http://www.technobots.co.uk/acatalog/Online_Catalogue_Electronize_Speed_Controllers_351 .htmlhttp://www.technobots.co.uk/acatalog...Speed_Controll ers_351.html
and a
RC speed control Microprocessor 15A Vreg
http://www.technobots.co.uk/acatalog/Online_Catalogue_Electronize_Speed_Controllers_351 .htmlhttp://www.technobots.co.uk/acatalog...Speed_Controll ers_351.html
what is the Difference in the 2

Would 2 RC speed control Microprocessor 15A Vreg work?

I have the batterys, reciver and two drill motors,I am just confused about the speed controllers

[joey_picus]

Youll need one of each...the Vreg model comes with a battery eliminator circuit which means you can power the reciever/servos off the controller as opposed to using a separate battery.

Two non Vreg ones will work as long as you use a separate battery...two Vreg ones will possibly blow up your reciever. Or so Im told :P