OK, cookie accepted.

Time for a new chassis. The number of holes Ive made in are starting take their toll. Its survived for over four years, so not bad going. Patch it up for Leicester and then rebuild. Got it all in CAD, so its basically print it out on A3 sheets, stick to the new lexan sheet and cut it out.

Hopefully going to go for a better way of connecting the panels together than drilling and tapping into the edges of the panels. Probably 3mm stainless angle brackets.

Planning some upgrades to the pneumatics like venting the regs direct into the buffer tank (rather than through the current ally block) to reduce freezing, but thatll be longer term.