Right... Here I Go Again

[paulc]

Ill be the first to enter, Mr Sheppard.

I BEATEN EVERYONE IN! At least if I dont win, I can be the first to enter

NITRO-GENE

€ WEIGHT: 100KG

€ ARMOUR: 4MM HARDOX

€ SHAPE: LOW INVERTIBLE BOX WITH SLANTED SIDES AND REAR LIKE TORNADO

€ MOTORS: 2 x ETEKS AT 46V = 30HP

€ LOCOMOTION: 6 VULKANISED WHEELS.

€ DIMENSIONS: (L) 80CM (H) 16CM (W) 60CM

€ COLOUR: RED

€ WEAPONRY: A FULL PRESSURE NITROGEN FLIPPER AT THE FRONT. AT THE FRONT IS AN EXTENSION MOUNTED ON A SLIGHT WEDGE (MOUNTED AT 15*) UNDER THE FRONT TO GET UNDER AND BRING THEM ONTO A NITROGEN POWERED FLIPPER THAT RUNS UP THE FRONT OF NITRO-GENE, AND DOWN BY 30CM. THE FLIPPER HAS ENOUGH POWER TO LIFT 1500KG.

€ SPEED: 18MPH

€ GROUND CLEARANCE: 0MM-2CM. AT THE FRONT ITS 0. AT THE SIDES AND REAR ITS 2CM.

€ STRENGTH: PUSHING POWER AND WEAPONRY.

€ WEAKNESS: HIGH SIDE GROUND CLEARANCE.

I hope this does you fine

Avarice

http://strickenone.proboards99.com/index.cgi?board=heavies&action=display&thread=1198 028093http://strickenone.proboards99.com/i...display&thread =1198028093

[tacoman]

If you would be so kind as to allow me a place:


NAME- Death Threat 0.1
SHAPE- Long box with rounded back,
COLOUR- dull grey all over
WEIGHT- about 100kg
DIMENSIONS- L:95cm W:70 cm H:30cm
SPEED- 10mph
TURNING CIRCLE- 0m
GROUND CLEARANCE- 10mm all over
ARMOUR- 5mm titanium
MOVEMENT- Tracks with 2XBosch Motors with 3 Ni-cad battery packs at 24 Volts
WEAPONS- Horizontal crushing claws at front made out of titanium with 4.25 tons of crushing power
SRIMECH- Invertible. Side spikes to stop it resting on its side

Name-Forklift 2
SHAPE- Low box with rear anti self flipping wedge
COLOUR- Yellowy orange
WEIGHT- 100kg
SPEED- 18mph
TURNING CIRCLE- 0m
GROUND CLEARANCE- 0mm at front due to flipper, 0mm at sides due to skirts 7mm with out, 0mm at rear due to wedge. The skirts are held down by torsion springs
ARMOUR- 3mm hardox
WHEELS- has 6 inner storm 2 style wheels
POWER- 2 x S28 Magmotors on 24v.
WEAPONS- it now uses a flipping arm that works much like the matadors or Toro€™s the flipper is powered by co2 on a 120mm pneumatic ram, working at 145psi, the flipper front is pretty unique as its front is like that of a fork lift (it has 2 flat bits of metal) this is welded onto the flipper, the arm can toss robots very high and if possible out of the arena. The prongs of the forklift weapon are used to get under the corners or gaps of skirts
SRIMECH- the flipper self rights the robot but because of the rear wedge thing it self rights like firestorm does i.e. the front wheels will go down first
NOTES- this is a modified version of my robot from the panic attack forum.
STRENGTHS- Power full weapon
WEAKNESSES- limited co2

The May Tracks Has You

Shape: Like Comengetorix. It has a wedge extender to give it 0 mm at the front.

Speed: 20 MPH.

Dimensions(lwh A): 85CM X 45 CM X 24 CM

Armour: 4.5 MM hardox.

GC: 0 mm at the front, 6 mm everywhere else, covered by skirts made of 3 mm Ti.

Weapon 1: Rear hinged flipper, powered by two pneumatic rams at 500 psi.

Weapon 2: Upward facing spikes on the wedge. A robot can go over them, but if it tries to reverse, say goodbye to your tyres. By wedging a robot then reversing suddenly, TMTHY can impale the tyres, then fire the flipper to do loads of damage. Even a robot with stuffed tyres will be limping after that.

Drive: Inner tracks, powered by Lem-130€™s at 24 volts.

Srimech: The flipper.

Strengths: Weapon synergy. Once The May Tracks Has You, there is no escape.

Weaknesses: Axe/flipper combos could take the tracks out.

*reserves*

what is your weight limit for tracked bots?

if 110, Sheer Heart Attack is in

(Message edited by MajinB on December 23, 2007)

[andrewj]

Name: SOR Hex
Shape: Box-wedge shape with sloped sides. These wedges are all angled at 45 degrees to give maximum protection against spinning weapons. If you are unsure, please check the render. The front wedge has a small €˜nose€™ on it which scrapes along the surface.
Length: 700mm
Width: 800mm
Height: 200mm
Weight: 100kgs (hasn€™t been fully weight checked for a while but should be under)
Drive: Two aluminium wheels coated in Vulkalon for added grip on the arena surface. These are driven by two LEM130 motors at 36v, provided by 90x 3000mAh NiCad packs. This gives a reasonable amount of push, certainly enough to drive at and under other bots.
Speed: 12mph
Ground Clearance: 0mm at the front wedge and 10mm elsewhere. The front also has a €˜nose€™ on it that sits flush to the ground and the sides are skirted, which effectively means 0mm at the front and sides.
Armour: 4mm thick Hardox all over, other than the skirting and nose which are 3mm Titanium.
Weapon: The main weapon is a central rear hinged flipping arm, which runs across the top of the robot and down the front wedge. This is powered by a 80mm bore 100 stroke ram fed with CO2 at 145psi. There is around 4.5kgs worth of gas on board which gives multiple flips during a match. It€™s designed to be long lasting rather than to throw people all over the place. For protection at the rear, there is a 25kg Horizontal spinning bar driven by an S28-400 Magmotor at 24v. This is spun at 2000rpm and gives off around 27kJ per hit.
Notes: Can run inverted and self-right using the flipper.

Ill put in Hypo Mk 3

For Tracked bots its 100KG, as I dont believe in the added 10KG allowed for tracked machines.

Matt have you got the stats for Hypo Mk 3, or even a link to a page with the stats on?