Spectrum system question

**psycho_fling** · 17th November 2007, 20:12

hi all

i now have a spectrum, and had put it in psycho fling but as only block of wood is going to nottingham i have decided to put it in there for that event. there isnt anything i need to do to it before swapping it over? its proabaly a bit of a silly question but block of wood wasnt working, i havent tried to fix it yet but want to make sure im doing everything correctly

thanks alex

**Kenny** · 17th November 2007, 20:24

with spektrums in different robots you would probly need to bind again has the failsafes might be in a different position???

**psycho_fling** · 17th November 2007, 20:32

ill read up on how to do that, matt did it for me in psycho fling

also looking for aanother reciever as i believe you can run more thanm one reciver off the same transmiiter is this correct? Ive been looking around on the net and have found one for Â£42, does this sound normal?

thanks alex

**team_mayhem** · 17th November 2007, 20:47

to bind it put the bind plug in the battery terminal the first 1 and then push down on the button on the back of the spektrum and turn it on the reciver should flash orange when it stops blinking and just shows the orange light take the bind plug out and your done

**kane** · 17th November 2007, 21:41

Important note:
When you bind the receiver to the transmitter, this sets the failsafe positions. E.g. When you bind, the receiver remembers the stick positions at that point in time. This is the only way you can set the failsafe.

As matt says, the bind procedure is as follows:
1. Plug bind plug into receiver BAT connector.
2. Turn receiver on (best to do this with only a receiver battery connected).
3. Press and hold bind button on rear of transmitter.
4. Turn transmitter on and keep holding button until receiver light goes solid.
5. Remove bind plug on receiver.
6. Turn transmitter of and double check failsafes work correctly.