Wiring a battle switch

[psycho_fling]

hi all

some of you may know i am going to build a crusher fw, i bought from technobots a battle switch and a relay to use the contriol for the crusher. im not ready to wire them yet but just need to know how, can anyone help? more details on each can be found below

http://www.technobots.co.uk/acatalog/info_3400_021.htmlhttp://www.technobots.co.uk/acatalog/info_3400_021.html

http://www.technobots.co.uk/acatalog/Online_Catalogue_Relays_360.htmlhttp://www.technobots.co.uk/acatalog...elays_360.html

the relay is the 24v one

thanks alex

[woody]

Youll want two relays Alex.... one for extending the linear actuator and one for retracting it.....configured like this ...http://www.teamonslaught.fsnet.co.uk/DPST.gifhttp://www.teamonslaught.fsnet.co.uk/DPST.gif

[RogueTwoRobots]

Im probably going down the Battleswitch path for controlling my crusher too and Im after the FWD-OFF-BACK control for my actuator; would I not be able to achieve that with just the battleswitch on its own? Or do I need the two relays as Woody described, as well as the battleswitch? (Ive never fully grasped the concept of how many/what relays Id need for controlling different weapons)

Cheers,
Jamie

[woody]

If you use a simple ON / OFF function R/C Switch ....like I believe the Battle switch to be .... then you wont be able to give the crusher the OFF function.
Youll only be able to get FWD ( extend to crush ) when you activate the Battle Switch and REV ( retract and return to the ready position ) when the Battle switch is OFF.

You really want a Robbe - Duo - Switch unit #83192000 or similar to activate some larger amperage relays.
You can then get your required 3 functions.

Oh! ....and youll also want a couple of microswitches to act as limit switches.
Im happy to knock up a wiring diagram if anybody requires one.

yes please, i dont know if you know woody but the battleswitch has 4 screw terminals if you could could you include which wire goes to which terminal?

thanks alex

[RogueTwoRobots]

Id welcome a diagram as well (cheers Woody!!) but having just had a quick glimpse on Technobots, Im toying with the idea of getting a Dimension Engineering Syren 10 Motor Controller (http://www.technobots.co.uk/acatalog/Online_Catalogue_Dimension_Engineering_Controllers _34.htmlhttp://www.technobots.co.uk/acatalog...gineering_Cont rollers_34.html) to control the linear actuator since, as far as Im aware, its a relatively low current-drawing actuator (2A I was told when I bought it) and that controller adds up to a similar cost to the Robbe Duo unit plus relays.

So I might give the motor controller a try and see how it performs

EDIT: Any luck getting an actuator for your crusher yet Alex?

(Message edited by K_C_R on November 07, 2007)

[woody]

Youll need to give me some idea of the notation on each of the four terminals.

NC - NO - BAT .....Etc.

ok they are ...

s1
sc
s2
nc

it gives some info

s2 to neg bat
sc to neg motor
s1 pos motor then pos bat

well im in contact with linak and have contacted other companies but no luck yet
thanks alex

[john_frizell]

If you want to run a motor with three options - forward, reverse and off - get an Electronize electronic switch from Technobots and make a 2 relay H bridge to go with it. The battle switch will only give you on and off.