Cradles

[psycho_fling]

hi all

on reading the rules and other documents about the uk champs the word cradle caught my eye. i realise that alot of the stuff may not appaly to a fether weight, but could someone explain what one is? do i need one? and how sould it be made (materials)?

thanks alex

[anukhet]

You will need one for your feather. I made one in 5 minutes out of 3 pieces of wood screwed together. It is required while the robot is on the bench to keep the wheels in the air and is sturdy enough to keep the robot steady while the motors are running such as during tech checking or bench testing. 1 inch by half inch pieces in an H configuration did the trick for Small Torque. Pillow Torques is I shaped.

[maddox]

A cradle isnt much more than a frame, made from any material , that makes sure the robots wheels cannot touch the surface of anything, so, if the drive is accidentialy activated, the robot wont destroy the pits. Of course ,the cradles need to be sturdy and put the robot stabile.

And a cradle is mandated for every weightclass.

Now, our featherweight cradles are just screwed together 4 by 4s.

[tough_as_nails]

Ok, but what if the wheels are on the ground, but not on the robot?

[robotwars]

ha ha jeroen.... maybe you should make a cradle for them too

john

[grant_ploughbot]

Alex, what have you been doing for your last few events? You shouldnt have passed a tech check without one, and certainly not been able to continue the event without one (or many events)

[psycho_fling]

well i havnt being using a cradle as such just something to keep it oof the table. but i have made one for B.O.W but never used it

[anukhet]

A cradle is basically something that keeps the robot off the table as you say. It doesnt have to be fancy as long as it is sturdy as mentioned above.

[big_nipper]

Little Hitter and Flipper basically have an X shaped bit of wood with some angle iron screwed to it to prevent the robot falling off the cradle. Big nipper simply uses its box lid turned upside down with just a couple of strips of wood keeping the wheels in free air. It is there for safety and to be able to test your drive during a tech check without the risk of it driving off.