Im new

[erik_knutsson]

yeah, i send them on your email Dan.

Instead of making several new threads Im gonna hijack this one.

Im not quite new to the Robot Wars sport, been doing Antweights for many years now, but recently I started up my Featherweight project again.

Specs:
Name: Accident
Speed: About 10km/h
Power: 2x 12V NICD packs
Drive: 2x 18V drill motors
Weapon: Vertical 180mm Hardox disc unknown motor.
Armour: Polycarbonate 10mm sides and HDPE 5mm top/bottom
http://i3.photobucket.com/albums/y89...nt20076.jpgCAD

[leorcc]

Hey Joacim,

10mm lexan is still pretty strong, but like with the antweights it all also depends heavily on the way you mount it. As a rigid construction polycarb is not able to withstand as much punishment as it would when it has a litte flex in it.

Still, 10mm will take some serious abuse.

[flippt]

Ok, but will some 5mm HDPE sheet bolted on the side amour be able to take some punishment?

Hi there,

I just bought some 12v drill motors from that site thats just closing down. When I take the torque control off loads of ball bearing fall out. Are they used solely for the torque control? do I need to stick them back in, somehow?

Thanks - Simon

simon,i just leave them out.

The ball bearings need to be replaced with locking screws or or youll get NO drive.
Some 5mm grub screws threaded down the holes are ideal for this.

Ady .....See me after class for some extra homework!

OK thanks, so two balls per hole and screw them in?

Simon

Nope .....no need..... just replace the balls with a 5mm crub screw.
Tap the holes 5mm first and screw in a 5mm grub screw till it contacts the gear inside.