O.K. Graig,

We are using the right hand transmitter stick.

Stick your bot up on blocks so that the wheels DONT touch the ground.

1. With the power off, plug the bind plug into the BAT port.
2. Power on the receiver by connecting the battery to any unused port. The blue LED should be blinking...This is the BEC plug from the Sidewinder ...and youll need to power up the Sidewinder by attaching the main batteries.
3. Position the throttle stick in the desired fail-safe position (normally low throttle).
4. Press and hold the bind button on back of the transmitter while turning on the transmitter. The button should
flash for about 5 seconds, then both LED€™s (transmitter and receiver) will go solid green.
Important: Remove the bind plug after binding.

You should only ever need to do the above once and can ignore it if youve already done the binding process.

Now turn everything off.

The other 2 plugs from the Sidewinder go to Aile and Ele on the BR6000 receiver.

Aile for Steering and Ele for Throttle.

Power up the bot and transmitter again.

Push the transmitter stick up/forward.. both motors should rotate as if driving the bot forwards ...if one motor is going in the wrong direction swap over the wires supplying it.

Try the left and right on the transmitter stick.

Turn left ...left wheel rotates backwards & right wheel forwards.

Turn right ....right wheel rotates backwards & left wheel forwards.

hopefully everything rotates in the correct direction....if not swap over the wires supplying the motors from one side of the bot to the other ....keeping the supply colours in the same motor connections.

Hope I have the above correct.

Im sure someone will correct me if Im wrong.