Hey guys not so long ago I just finished building my first proper robot based on Rex€™s robot challenge and I was wondering if any one could help me convert the bike pumps into proper rams. I haven€™t yet battled my friends but what would be a good alternative without having to go and buy full pressure co2
woodys the best and probably safest person to talk to.
(Remainder of post removed by Admin.)
(Message edited by scorpion on May 29, 2007)
If you want a proper ram ...buy one.
The bike pump could be considered a very low pressure ram .
Id suggest that you follow the guidelines set down in Rexs Robot Challenge.
(Message edited by scorpion on May 29, 2007)
Yea ok fair enough are there any websites were I could get a starter kit on low-pressure pneumatics or does this (starter kit) not exist and I will have to get all the parts individually
Ah second thoughts does any one have any to sell
hmm... my post got edited :S
Adam, without knowing what pneumatics experience you have it is difficult to recommend something. But any components that you use must be suitable for the pressure you are running at. Off the shelf items are usually tested at a lot higher pressure than their recommended running pressure.
The best advice is to design a system, seek advice on parts needed.
A basic system will work something like this for a low pressure system.
Main tank - regulator - buffer - main valve - ram
(Message edited by geeza on May 29, 2007)
Thanks ED I have only covered the basics of pneumatics in collage using compressed air I guess for now the bike pumps will do as its only my first proper robot, before I built this one I just used to put a wooden body shell over my RC car and then wire up a 12v motor with a blunt cutting disc on it.
I got a feeling that I properly design a co2 system for my next robot and then one day I might start attending live events
Posting Permissions
Bookmarks