Reciever Battery packs

[woody]

These are fairly normal switch / charger harnesses ... ignore the blurb calling them a receiver box.

http://www.abcmodelsport.net/p389307/CHARGING-SWITCH-HARNESS-FUTABA.htmlhttp://www.abcmodelsport.net/p389307...SS-FUTABA.html

http://www.abcmodelsport.net/p389310/SWITCH-HARNESS-FUS-CHARGE-MOUNT-PLATE-JR.html?image_id=148504http://www.abcmodelsport.net/p389310...NT-PLATE-JR.ht ml?image_id=148504



(Message edited by woody on June 15, 2007)

[xtreme]

is it like this?
http://cgi.ebay.co.uk/HPI-FIRESTORM-POWER-SWITCH-RECIEVER-BATTERY-CASE-NEW_W0QQitemZ280120389269QQihZ018QQcategoryZ19168Q QrdZ1QQssPageNameZWD1VQQcmdZViewItemhttp://cgi.ebay.co.uk/HPI-FIRESTORM-...CASE-NEW_W0QQi temZ280120389269QQihZ018QQcategoryZ19168QQrdZ1QQss PageNameZWD1VQQcmdZViewItem

[psycho_fling]

well the one currently the switch has the end to go into the reciever, and the end that connects to the battery box just has space to fit a 2 wired attchment in, if that makes sense. but the reciever has three

so three wont fit into two

thanks alex

[woody]

But there are only 2 wires involved even if the plug has 3 pins.

Hi Alex,
I use the futaba switch,it has an extra lead which plugs in to a standard charger so that when the switch is off it allows you to charge your battery without taking it out of your bot. i found that pushing and pulling the reciever connector ends up with loose connections which leaves you dead on the arena floor:sad:

http://www.abcmodelsport.net/p389307/CHARGING-SWITCH-HARNESS-FUTABA.htmlhttp://www.abcmodelsport.net/p389307...SS-FUTABA.html

My switch is on the side of a small plastic box which houses the reciever, battery and scorpion speed controller.

[psycho_fling]

right the battery pack has a three pin wide attachment, even though it uses to wires. so therefofre will not fit into a connector 2 pins wide, its like trying to fit a square pin into a circle hole

alex

[psycho_fling]

would this one be suitable from technobots?

3601-032

alex

[woody]

Yes.

cheers woody