Ed/Simon/John
4.10 in its past form has been removed in version 1.2 of the rules which is due release May 1st.
It was removed after feedback that suggested it was contradictory to rule
6.4, which has also been re-worded in version 1.2 in order to clarify.
This was part of the process of re-wording to make things more clear that has been requested through feedback from the community.
It was always the intention that RX switches be mandatory, this does not constitute a rule change.
To explain a little better why the RX switch is required.
Loss of power to the RX is an entirely different failure mode to loss of signal (i.e turning off of TX). It can result in some systems in not only losing power to the RX but also the failsafe which is in line with it. This can in turn result in a servo based system in the servo staying in last position, which in worst case means the robot will continue to move/power its weapons.
Where a code-based system is utilised, if this is not set up to return to neutral on loss of power, this can also result in a continuation of movement.
To conclude:
An on/off switch for you RX is a mandatory requirement for all Featherweight, Lightweight, Middleweight, Heavyweight and Superheavyweight robots; in practice this switch when off must place your robot in failsafe status.
I hope that clarifies the situation.
Regards
Samuel Jones
FRA Safety Executive




Reply With Quote
Bookmarks