3D Printing Advice

**Coolspeedbot** · 7th April 2019, 21:04

Basically put legs under the over hangs using 2mm thick squares or circles. Theres some examples on this page of my antweight build diary: http://robotwars101.org/forum/viewto...2507&start=135

8th April 2019, 02:18

Cheers! Thatâ€™s a big help! Iâ€™ll sort them out in the morning and get it printed! So once it comes just snap or trim off the supports? Also I was going to ask what sort of size depth for the actual sides etc? You said 2mm for the supports, Iâ€™ve gone for 4 mm for the sides at the moment, is that too thin?

Bad Wolf

Thread: 3D Printing Advice

Thread Tools

Search Thread

Display

Hybrid View

Bookmarks

Bookmarks

Posting Permissions

Site Map

Event Organisers