There's plenty of force in it too, this is what it did to 1.8mm titanium, and underneath it is 10mm aluminium
p5u8Wu!LaD.jpg
There's plenty of force in it too, this is what it did to 1.8mm titanium, and underneath it is 10mm aluminium
p5u8Wu!LaD.jpg
Been working on BOB2 to take on Robonerd and to use if there's a season 3 Bugglebots.
BOB2 is what the FW BOB4 going to be with the axe and other things.
Got it all wired up ready to test the weapon, fuse blown no problem got one with a higher amp, tried again and now this.
20190829_183949.jpg
I know there's a hobby shop next to my old job where I get a new motor. If I can't get one it'll have to go in weapon less on Saturday.
You could probably straighten that shaft with a panel pin hammer and the flat anvil bit on your vice
but is does require a steady hand
Overdue update.
Renamed BOB 2 to Little BOB so we know which BW, FW I'm talking about.
For those who have seen the Robodojo live stream. It didn't drive well, a button head screw at the back helped but I'm not getting much power into the wheels. When I checked what RPM my motors have because I forgot what it had, it said 1000RPM I wonder if went for speed over power.
Next is the weapon, the belt was too lose simple as that and the funny thing on the earlier build was too tight.
Also, Little BOB was a bit overweight.
To-do list.
Go from 2WD to 4WD
Make it liter
Get the weapon to work right
If needed new motors with lower speed.
Bookmarks