Register To Comment
Results 1 to 10 of 90

Thread: Ant Weight Circuit Help

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. 21st February 2018, 16:56 #1
    Scottie's Avatar
    Member
    Why does only one JR wire need to be fully soldered? So I don’t need all four wires into the DasMikro from the JR cables?
    Assuming that the on board regulator is powering your lemonRX then you only need one 5V wire and one GND wire to make a complete circuit as all the GND pins are linked together on the lemon, same thing with its positive voltage pins. So on one of the JR cables you can leave them unsoldered. I would advise that you cut them in such a way that the metal parts of the wires cannot touch.
    Reply With Quote Reply With Quote
  2. 21st February 2018, 17:14 #2
    Bad Wolf
    Guest
    Quote Originally Posted by Scottie View Post
    Assuming that the on board regulator is powering your lemonRX then you only need one 5V wire and one GND wire to make a complete circuit as all the GND pins are linked together on the lemon, same thing with its positive voltage pins. So on one of the JR cables you can leave them unsoldered. I would advise that you cut them in such a way that the metal parts of the wires cannot touch.
    My heads abit mashed on this point, but say there is 4 pads for JRs, I solder 3 out of the 4? And leave 1 wire not soldered? And snip it off short so it can’t touch anything else? If so, which colour, black or red?

    Bad Wolf
    Reply With Quote Reply With Quote
Register To Comment
« Previous Thread | Next Thread »

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules