On a different note. I found that these motors are very thirsty. I pluged one of these motors in to an afro 12A esc and enabled bi-directional control. I found that at about 50% throttle I was drawing about 7A on the DC side. I didnt see if it could go further, mostly because I didnt have a power supply that could go any higher. I am finding this a bit odd because im essentialy running this motor with no load, so I was expecting a much lower current draw.

Perhaps I should reduce the ability for the motor to draw current on the ESC. Is anyone familiar with the BlHeli suite? I believe that i would have to reduce the motor gain? im not entirely sure.