Hey everyone,

I have been wheel shopping and I found a cheap wheel which I thought was the right bore (It was advertised as 9mm bore). I thought with that size I could screw it straight on but no such luck unfortunately! It's actually about a 10mm bore which is a little too big.

20170519_201235.jpg

So I had a look at Ellis's videos, like R9000 suggested, about melting the brass nut into the wheel. This looks like it will be a good plan but I just want to make sure of a few things first!

1: Does this look like the 3/8 UNF thread? Because the guy in the DIY store seemed to think it was a 10mm x 1mm machine thread. Is that the same? I done know xD What do you guys think?

20170519_201223.jpg

2: Whats the proper name for the brass 1 inch nut thing Ellis used? cus I cant find the bleeding thing! lol

Thanks a lot everyone for your help!

Will