Not the dumbest of dumb questions I've asked. BUT....... these linear actuators. the mount holes hold the ram with the motor above it. This caused problems with space inside the bot. SO. could I drill new holes sideways into the existing ones so I could possibly mount it with the motor to the side of the ram itself.?!?
Just brain storming a back up plan!! Always have a plan B!!
If you have 2 small plates either side of the origonla hole with a bolt through and then weld a couple of bolts with their heads cut off sticking out sideways from the ends of the plates, between them, you will be able to have a universal joint and not need much more space.Originally Posted by cjsowry
Not the dumbest of dumb questions I've asked. BUT....... these linear actuators. the mount holes hold the ram with the motor above it. This caused problems with space inside the bot. SO. could I drill new holes sideways into the existing ones so I could possibly mount it with the motor to the side of the ram itself.?!?
Just brain storming a back up plan!! Always have a plan B!!
took me a few minutes to figure it out, but yes. good idea...
Posting Permissions
Reply With Quote
Bookmarks