Experience needed regarding FW Beater and Armor

[Runsler]

Ah well, will have to see if i can find a suitable design for the discs, anyway.

Solid they would be a bit more than 4.5kg each, so more than 9kg total, assuming 12mm hardox as earlier in this thread was mentioned.

Well... the first beater design would come in lighter, so this would be quiet pointless, and only make the work a bit easier, but still not practical at all.

Maybe if i try something along what Wrex for example uses, more a spinning ring with lets say three spokes. might need a bit more than 12mm thickness then. Have to try that and see how heavy it is. If not, i might have to go for the single disc or beater in the middle solution, or take a double bar spinner instead. Although these seem to be extremely unpopular as vertical spinners. Is that just because they have inefficient weight distribution, so they are usually just used with bigger diameters (so: horizontal spinners)?
Can only remember two verticals with a bar, one of them being "Huge", and that one is special, anyway.