If you do it right, the welding doesn't distort the HDPE.
And woodscrew don't cut the cheese. T and barrelnuts are the better options.
If you do it right, the welding doesn't distort the HDPE.
And woodscrew don't cut the cheese. T and barrelnuts are the better options.
I might test my plastic welding skills on some offcuts lol
With the proper heat gun, welding is really easy - I figured it out in about 5 minutes after watching a couple of videos. For thick and structural parts of a frame, I would still use barrel nuts; they are likely to be stronger and allow you to replace damaged sections.
Nick, you figured out TIG welding , and TIG welding Ti after watching a few video's. It seems you're a natural.
But yes, HDPE welds tend to be more brittle than the base material and benefit a lot from some metal reinforcements.
Hardly a natural, I still suck at welding steel for some reason. Another reason for getting set up to weld HDPE is that the hot air gun can also be used for heat forming - 5mm HDPE bends very easily and 10mm bends with a bit of patience.
Hi Guys,
I've been thinking about chassis material recently too..... I'm considering using a 3.5mm Mild Steel Angle welded to make a frame chassis then bolting HDPE (6, 8 or 10mm depending on weight) as easily replaceable armour panels.
Does this seem like a daft idea? (I'm thinking it might be as I don't see anyone else suggesting this method )
Cheers,
Alex
Im sure a much more experienced head will help you out but that sounds like a fine idea to me, I take it that you are building a feather?
A basic steel angle "wireframe" with bolted on HDPE sheets. Works.
But I would suggest using other material than DIY grade steel or even worse, cheese grade ali.
I know at least 1 feather that uses hardox strips to connect the sheets.
Thanks for the info guys..... I think I'll stick with the Steel Angle chassis with HDPE Pannels bolted to it, but maybe the Mild Steel Angle I picked up cheap from my local B&Q that was shutting down isn't the best...
Cheers,
Alex
Bookmarks