http://m.ebay.co.uk/itm/311311059992
a thread for the odd question i may have.
First has the name atom been taken?
Also anyone tried these speedo's ive linked their rated at 16v max and have you ever overvolted them?
http://m.ebay.co.uk/itm/311311059992
a thread for the odd question i may have.
First has the name atom been taken?
Also anyone tried these speedo's ive linked their rated at 16v max and have you ever overvolted them?
i use them in night fury and scruffy but there are a few software versions on ebay so only some work properly
Ok. i was gonna try some as a punt as they were cheap. I have a scorpian in another robot so will use that.
I am replacing a motor on my k9 but i need some reverse screws for the drills can these be bought anywhere seperately.
Last edited by ady; 8th March 2015 at 18:34.
unfortunately the supplier i got mine from seems to have stop selling them each esc will happily run 2 drills on 4s and barely get warm after 3 min
They kept coming loose on k9 so i threadlocked them. Think i overdone it with the threadlock and ruined the screw getting wheel off lol. My spare motor also seems to be missing the screw i think their m5 or m6 reverse thread.
I had a set of those ESCs in Hardwired 1 and they had a brake function on, but happily took 2 drills each. They did also eat themselves after I put them in my beetle. They work fine in Scruffy/Night Fury from what I've seen but it's all really dependant on you getting the right ones which as far as I can tell is pure chance unfortunately...
thanks for comments i think i will pass on them and just share my scorpian between this fw and k9, not a problem.
Ok. I need to bend some 8mm thick strips of hdpe about 2" wide. I have a heat gun for paint stripping is that a good method? Or put it in the oven? Wondered what others have done and will it hold its shape once cooled.
I use a combination of L angle and a dedicated (Leister) plastic bending/welding heatgun.
Or for smaller bits up to 110mm wide, I take up my bender, and go with the heatgun again.
Ady if you're still after reverse thread screws I have a couple spare you can have, m5 ones.
Bookmarks