A fuse is an electrical item, rather than an electronic device, but that's just me splitting hairs.
When you run components in your robot (such as motors), they draw an electrical current from your power source; in this case, your batteries. Most of that energy is converted into motion (your motors turning) but some of it is converted to heat. If there is more resistance in your components (say you're driving the robot into a brick wall so the motors are pushing against a solid object), they draw more current from the batteries which, in turn, also generates more heat. Every electrical component, so speed controllers, wires etc, will have a current rating, given in Amps. This is how much current the component can comfortably handle; if you greatly exceed this rating by drawing more current, you will likely destroy the component as it is unable to get rid of the excess heat from the higher current, hence the smoke/fire you get from a speed controller if you exceed its operating spec.
Fuses are designed to protect against this happening to components. They're basically a piece of wire or strip of metal that is designed to melt/break, caused by the heat, when a certain amount of current is drawn through them. They're usually designed to be fast-acting so that they blow quickly before the current has a chance to cause damage to your electronics. It's much cheaper to replace a 10p fuse than a £100 speed controller.
Fuses are recommended on all robots but are only mandatory on robots that run li-po batteries in the featherweight class or higher, though I believe it may be making its way down to the beetleweights.




Reply With Quote
Bookmarks