RC Valve Controller Development

[Rapidrory]

Ok, so back on the original topic of this thread, the valve controller has now been successfully tested for a few events in Dystopia (the valve controller worked fine, even if the rest of the machine occasionally didn't :L ). This was running 2 valves on separate channels at 36v, so fairly typical usage in a heavyweight, and there have been no issues with it. I've just bought in a stock of components, so these things should now be ready to sell.

Prices are looking to be:
£15 for a single channel switch
£20 for a 2 or 3 channel switch (uses different board)
£2 UK Postage (will have to check price for further a field)

Single channel default operation will be on for up, and off for centre stick and down.
Two channel default will be channel A will be on the up stick, channel B will be on the down stick, and both will be off on centre stick.
Three channel default will be channel A will be on the up stick, channel B turns will be on centre stick, and channel C turns will be on the down stick.

I can set up the channels for any combination of up, centre, and down that you like, so just tell me what setup you want. Do note though, I haven't tried firing multiple burkets on one channel with this at once, and although it would probably be fine, if possible it would probably be safer just to use two channels set to fire at the same time, so bear this in mind when ordering.

I don't have a new picture, but I'll just repost the one of the single channel switch from earlier in the thread as they haven't changed at all:


If you're interested, either PM me or email me at rapidrory@gmail.com. Payment is via PayPal to that same address.