HardWired II

[Flag Captured]

I'd hope it wouldn't get to the point of having batteries smashed up, but it's nice to know that there's a gentleman's agreement!
It's 20mm HDPE I'm using, may bolt other things to it if it turns out that it's well under weight which I seriously doubt, but I'd hope that say, 8mm screws would be alright since that gives about 6mm either side of it? I might help support the 2/3mm stainless base using some L-angles, just so that the linear actuator (if it fits) doesn't pull it off by mistake or anything! My only worry is my slightly unusual design on the back end, it's not final but it's this weird sort of half-hexagonal shape, designed purely to give spinners a little less to bite on but can revert back to square if needs be. Would like it to look a bit more interesting though if I can, got some plans for that but I'll see how things go...

The plastic's apparently due this Monday, not yet sure about the drive/scoop though - whenever it's all here, expect plenty of pictures!