Boring Brick

[mrsam]

Okay like an idiot i hadn't wired the BEC circuit together (remebered there was one AFTER ordering a battery), the robot now works however it doesn't failsafe, if i turn the TX off the motors just start spinning by themselves, any idea how i can make it failsafe? the RX im using ishttps://www.hobbyking.com/hobbyking/..._Receiver.html and the transmitter is http://www.horizonhobby.com/products...20sr-EFLH1064B

[Niels - Team K.a.L.M.]

What you should do:

Power up your transmitter holding the trainer channel, uppermost lever on the left en hold it for the moment.
Power up the robot with the bind plug in the receiver.
After the lights come on pull the bind plug out of the reveiver.
Release the trainer switch.

The receiver will now have memorized the failsafe settings your transmitter was sending at that time.

Before you do all of this make sure all your wheels are stationairy so it will shut down completely once you switch off your transmitter.

I use a dx5e with the 8 channel version receiver you have.

[Niels - Team K.a.L.M.]

I'm interested to see how you'll develop the design of your machine.
Square boxes don't have to be boring looking

IMAG0170_zps6d2ca061.jpg