Register To Comment
Page 7 of 20 FirstFirst ... 5678917 ... LastLast
Results 61 to 70 of 198

Thread: No Toy Robotics

  1. #61
    Wiring up my weapon control, technobots twin relay got it set too oposite controls, ie ex open inlet closed
    using my rudder stick but it seems slow and when link is in the exhaust opens with or without bec on, this is safe but is it correct
    anyone post pics of there fire control designs

  2. #62
    Send a negative feed to one side of each of your coils on the valves. Feed a positive to the two commom terminals on the switcher, the a wire from the NO terminal on one side to the fire valve and the other NO terminal to the valve on the other side. That way you use the stick one way it will fire, the other way will exhaust, middle will hold the arm where it is.

  3. #63
    Thanks for reply all sorted and tested, full pressure gas test tomorrow
    20131209_192011.jpg

  4. #64
    http://m.youtube.com/index?&desktop_uri=%2F

    quick link to ceros flipper test, only low pressure was tested on a regulator due to no armour or bungee system enjoy

  5. #65
    link doesn't work but manage to find it, what pressure were you testing it at

    Last edited by plargen; 11th December 2013 at 20:52.

  6. #66
    Not sure at a guess around 5-8 bar no gauge on the reg but was only cracked open,high power acl valves worked well,will test again with gauges etc after christmas

  7. #67

  8. #68
    Looks pretty cool mate

  9. #69
    thanks for replys, looking at no toy soon what mod gears tend to be used for a speed 900 drive gear reduction
    looking at about 4;1 gear reduction and 100mm wheels

    So speed 900 drive
    Speed 900 twin axe motors
    22.2v lipo

    will be fun, same problem as always weight

  10. #70
    If you mean the well known Graupner Speed 900s at 6s, 4:1 and 100mm wheels, you're looking at a theoretical top speed of almost 40mph. I'd gear down a lot more. In most arenas you'll never really see more than 15mph, 20mph from one end of the heavy arenas to the other, perhaps.

    If these are slower revving motors, say 4000rpm @12v or something, you're still looking at nearly 25mph at 6s.

Register To Comment

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •