nothing but trouble rebuild! (fw)

[calumco]

been wanting to make a nice cnc'd feather weight flipper to go with TS3 kinda thing for a while so started it just over a week ago.- making it sorta flow! style as i've always liked the look of it.

picture of the base plate below, 10mm with 6mm deep pockets, the 2 cental slots are for the bulkheads to fit into when they are made.

when both motor gear boxes are done and bolted on will weigh an estimated 2.8kg. Thats without weight saving on the motor mounts yet too.

im going to have the ram bolt to a billet thats then to the base, this will allow me to swap rams out easily, as im putting a low pressure ram in for now but would like to make my own eventually perhaps on full pressure once i no how to use works lathe!