Compressor-based flipper

[Danjr1]

Im just wondering if anyone could give me a quick run-through of how the flipper shown in the link below works. I understand the basic principles etc but im just wondering what kind of compressor would do the job in terms of PSI required and where i would get one from. also, would i need buffer tanks etc? obviously wouldn't be looking for FP power but i like the idea of how light and compact this type of system would be.

http://askt47.dsl.pipex.com/Robot_WarsS ... ojects.htm

As far as i know, little hitter uses something similar to this?

Cheers

Dan

[typhoon_driver]

You won't get FP from that type of compressor. It's basically the compressor from a car tyre compressor used to pump tyres up so is good for a low pressure system. A buffer tank would be a good idea. Little hitter uses a conventional pneumatic system

[Danjr1]

thanks. always thought little hitter used something different! may have to get hold of a 300psi car tyre pump and see how far i can push it then! cheers

[Anttazz]

Think the original LH, Blue used a compressor. Maybe thats where you're talking about?

[blazerbotics]

You'll be lucky to get anything more than 50psi out of one, no matter what it says on the box. Compressors have been tried, and they don't work, best stick with CO2.

[plargen]

I've been messing around with the idea of using a compressor and the 1 i have hooked up to an old extinguisher can reach 150 psi cos ive used it for testing valves and rams

the difficulty i've found is getting a 12v pressure switch

[maddox10]

How long did it take to fill the buffertank?

[plargen]

unfortunately i cant remember but i can time it tomorrow i have been over vaulting the 12v motor to 14.4v generally and the buffer tank is a 1 kg extinguisher

[terry]

Stick with co2, I would imagine compressed air will not be allowed anyway as it would fuel a fire, co2 is non flammable.

[plargen]

the rules say air is allowed