Guess you're right maddox, the elbow fittings from the QEV to the 5way valve are a bit stressed - think I'll replace them with threaded 90' fittings, should come shorter than the current set-up and the fittings will be better aligned.

Here is a clip(Hope it works!) of the LP system test. Didn't bother connecting the solenoid, the valve has a manual deploy button :wink:
Looks like it's working ok, will have a better idea when the actuator is finished and tested



Progress with the build of the chassis and motor housing is in good progress as well,

Started off with these motors



Took them apart



And put them on a diet



After some sweat and a good slimming treatment with the belt sander they look like this:



Now the motors can fit into this... the motor housing/retainer



Motor housing bolted on to baseplate



bottom view of baseplate



And these are the parts competed so far




I'm happy with the progress so far, not much problems till now apart from HDPE being a bit difficult to work with till you get used to it. Hope that by next week I'll get the actuator and wheels, I want to see it moving