Quote Originally Posted by Mokichi
Ah well I suppose I'll give my table-saw a go then Relentless!
Why not? If the blade isn't to worn out, it will go trough like a good knife trough butter.


I don't fancy using L brackets particularly much, I do still have some angled aluminium (2cm x 2cm x couple metres) which I could nut and bolt the plastic too but think it could be a bit much effort perhaps.
It's the simplest trick in the book to do the job.

Max - That idea does look pretty good (same as the barrel nut idea?) but I'd still have to tap the aluminium myself would I not?
Yep, in the case of the piccy it was an M6. But if you are working in 10mm HDPE, I feel an M4 will be better. And I use my batterydrill for tapping, just putting the clutch in the right position to avoid breaking taps, using cutting fluid and making shure it's straight on the hole.