Bulldog Breed

**mattsdragons** · 5th May 2012, 14:14

Yes, that's right, the dog is back

Spent about an hour with tony today going through a full gas up, quizzed me to within an inch of my life on pneumatics and safety and he felt I was safe to take and run Bulldog Breed

Is fully working in its current state, but just needs to a RX and TX conversion along with a flap made for the link etc as you currently need to take the whole plate off top get too the link and gas up

will keep updated with pics etc when work happens

**mattsdragons** · 12th April 2013, 16:50

Been very quiet with Bulldog Breed, now the FW champs are out the way its my full priority, started to put it back together so I can figure out were everything will go, then take it all apart again to do all the upgrades

It will look fairly similar to how it did before but you will get one hell of a punch when that flipper fires

**mattsdragons** · 13th May 2013, 18:12

New battery cases and roboteq mounts done today, will get the chains back on this week, wire it all up and give it a test drive then its onto the new pneumatics

**mattsdragons** · 18th June 2013, 15:18

Bulldog has taken a back bench for a while but I am pleased to announce that I will be teaming up with 2013 FW annihilator champion 'Calumco' for the European Championships in September.

We shall be working jointly to get Bulldog Breed in the best condition its ever been in, shall be taking out time to ensure we have both a strong but reliable machine ready for battle