It was pretty much 1/2"UNF, the diamter was a bit too small but 1/2"UNF is the closest so I'll go with that.
Also, what kind of rpm do fw full body spinners get? I'm looking into using a friction drive to the edge of the shell (16" diameter) but this means I will get about a 8:1 reduction so trying to find a brushless motor with the right Kv
I think Little Spinner 4 touches 2k. I don't think many go beyond 3-4k.
If you're running around the rim of a shell, make sure the shell is very strong at the transmission point. If a big horizontal were to smack the shell where the friction wheel is running on the other side you'll have problems.
Would it be allowed to have an electromagnet in my fbs featherweight that would switch on just as I hit another robot. It would then stick to the floor for say half a second then it would turn off, this would stop the robot from getting thrown out the arena. Obviously it has certain practicality issues associated with it but theoretically would it be allowed?
We put an electro magnet in Splinter without issue. Did run in by the RC guys and Kane though.
How does a friction shell spinner work
Basically the motor is running a grippy wheel/roller against the inside of the ring, making it rotate on friction alone.
More progress on the heavy:
My feather is there next to it for a size comparison- it's scary how much bigger it is!
Cut out side armour from 4mm steel, was all cut out by me with a plasma cutter so all the lines are wonky and many of the panels were too small despite me having a guide but ah well! The panels are welded together at the back to increase strengh and have a crazy number of holes drilled ready for fixings (c.100).
Once I've decided where everything has to go I may weld some additional supports to the inside to further increase strengh as I am still concerned about that ali frame.
Also got some go-cart wheels and some taperlock bushes so just need to make a plate up to connect the taperlocks to the wheel hubs.
Any comments welcome!
Looks good keep up the good work, ali is soft even in angle form reinforce as much as possible
Can you get a voltage boaster to run Burketts or am I better with a small 36v battery pack?
Could I use this to step up my 12v battery to 30v for the burkerts? Not sure what current they draw.
http://www.banggood.com/3A-LM2577-DC...FUgJwwod2U8Adg
Posting Permissions
Reply With Quote
Bookmarks