Thread

**jonny** · 9th February 2012, 20:52

pugster, cover where the bar is connected and the shaft in araldite to prevent it coming off, also on the thread area so it doesn't un screw.

**harry hills** · 9th February 2012, 20:57

or just use the sensible, balanced discs that andy offered

**Pugster2002** · 9th February 2012, 21:02

the blade is welded on :shock:

**harry hills** · 9th February 2012, 21:06

anyway, what did you do to the servos again?

**jonny** · 9th February 2012, 21:08

good!

**Pugster2002** · 10th February 2012, 07:09

Originally Posted by harry hills

anyway, what did you do to the servos again?

i burnt them out because i didnt modify them right

**harry hills** · 10th February 2012, 08:04

what did you do to modify them?
what voltage did you run them at?
servos don't tend to smoke becuse of badd modding

**Pugster2002** · 10th February 2012, 09:37

Originally Posted by harry hills

what did you do to modify them i did not set the potentionmeter right?
what voltage did you run them at at 7.4v?
servos don't tend to smoke becuse of badd modding

i think the reciver might have caused it because it didnt seem to work properly the light didnt come on and it didnt controll properly but when i used my ant weight reciver [wich is the same make reciver]it worked fine.