Speed controller

[Gabe01]

I think it will be the one I go for, any issues with ordering it from the states?

[harry hills]

one i ordered took about 2 months to get here, but apart from that no.

[billy breach]

Im putting a fuse before each esc, im using electronize, 15a, drill motors and 18.5v lipo about 4000mah. Can anyone suggesy a fuse size for before my esc?

[botmad]

Clue is in the esc your using ...... 15Amp ????????

[RogueTwoRobots]

I've run 25A fuses in line with Electronize 15A controllers before without any trouble. Over-rated enough that it doesn't blow at every sign of a 15A current, and under-rated enough that it'll still blow before doing any damage to the speed controllers.

[billy breach]

Perfect ill get a few 25amps then. What size of fuse do you think to place just aftery lipo battery for the full system. I was thinking 100amp?

[RogueTwoRobots]

What is the 'C' rating of your pack(s) again? Just multiply that by your Ah rating and that will give you the maximum current the pack can output (if I picked that part up correctly). Then put in a fuse slightly lower than this.

[billy breach]

I havent got the lipo pack yet but itll be 18.5v and either 3500 or 4000 mah

[PJ-27]

The 15a Electronizes have a 40a peak rating so I use 30a fuses.

[billy breach]

is that a 30amp throughout the full system or 30amp before the speed controller (or after the battery?)