Quote Originally Posted by Hard Time
I found a way of not spending much money
Im going to take the pin valve off the bottle and make an adapter
The bottle thread is 5/8 - 14 UNF so im goig to make an adapter that will be 5/8-14 UNF to 1/4 BSP
The 1/4 BSP will screw into a on/off ball valve and then I will have another adapter that will be 1/4 BSP to 7/8 UNF that will screw from the ball valve to the reg.
Will this work?
If your regulator is not directly connected to the bottle you will also require a T piece and a 1000psi pressure relief device.
So in the instance of a screw in valve you would need to have an on/off valve also and this means you also require the 1000psi pressure relief valve before the regulator.
I would recommend using a bottle with an on/off valve rather than a pin valve.