Inertia XL

[teamshock]

Inertia has had some work done on it today. The new disc mech has been finished and attached to the base. The new ratio seems to be way better when run off the old 24v Ni-Mh pack so should be even better on the 8s A123s.

After having a good think I decided to ditch to speed 900 drive system in favour of a couple of Gimsons which freed up more weight for even more armour and a new reinforced front scoop. Tomorrow I will fit the drive and armour, wire it all up and give it a test.



I have also been working on Inversion- a 2WD brick that will be a bit of fun to drive in whiteboards. The shell is 4mm Hardox and has the speed 900 drive that was meant for Inertia. Eventually I will fit the Bosch's for a little more power.

[SamO]

Eventually I will fit the Bosch's for a little more power.

What motors are you talking about here?
I'm kind of thinking bosch 400's?

[teamshock]

I've got a pair of the 120w Bosch motors which I may fit.

These ones