-
Fleaweight
I'm going to sell my fleaweight in order to fund a second pneumatic ant project:
only competed at the last AWS/FWS so isn't too beaten up appart from a bite in the flipper.
-3D printed nylon chassis
-2x turnigy 14g micro servos speedhacked with a case modification, as usual speedhacked servos are prone to coming unglued if you run them hard or for a long time but they are easy enough to reglue. all metal gears. quite nippy even on the 14mm rubber tyres.
-1x turnigy 14g all metal geared servo for the flipper, activated through a linkage.
-2 cell 7.4v lipo, 130mah high discharge (25c) turnigy nano tech.
-orange 2.4ghz reciever all the connections are soldered direct to the board. this will require your own 2.4ghz dsm2 transmitter. I can solder in a bind plug if somebody would prefer.
-There is a voltage regulator in the back to run the robot on 6v.
It currently has a quick polycarb skirt that I put on for the aws as I didn't have time to mount the carbon fibre Piece I made. I will include the carbon fibre moulded armour if anybody wants to have a go at fitting it.
It currently weighs 65.8g with the polycarb skirt.
this isn't a toy it was built to compete so anybody looking to purchase this to run around for hours on end this isn't suitable, it should be run for 5 minutes max to save burning out drive and over discharging the lipo.
any questions please ask, open to offers send me an email: josh.valman@hotmail.co.uk
http://i22.photobucket.com/albums/b3...v/df4d916a.jpg
http://i22.photobucket.com/albums/b3...v/bae7e955.jpg
http://i22.photobucket.com/albums/b3...v/30c4e5c1.jpg
http://i22.photobucket.com/albums/b3...v/4728ed57.jpg
http://i22.photobucket.com/albums/b3...v/9717061e.jpg
The carbonfibre can be seen just placed around the robot here on the right: please note it cureently does not have any way of mounting it and this would have to be developed with some brackets or glue if you really must.
http://i22.photobucket.com/albums/b3...v/55652a90.jpg
-
Re: Fleaweight
The single piece chassis and flipper arm can be seen uploaded to my shapeways account and viewed in 3d here:
http://www.shapeways.com/model/274270/v ... tml?gid=ug
-
Re: Fleaweight
I am tempted by this, it would allow me to own both halves of the clusterbot from the AWS ;P I don't think I'd be able to properly look after the robot though...if it went without the carbon fibre shell would you consider selling that separately?
-
Re: Fleaweight
I have another slightly different shell if that's what you're after joey? it weighs 16.3g much thicker and more rigid but about the same size:
http://i22.photobucket.com/albums/b3...v/38c66b80.jpg
-
Re: Fleaweight
-
Re: Fleaweight
Replied to everyone. Will got in first so priority goes to him but otherwise it'll go to the highest bidder