looking at the picture of the print on the bed, it looks like your nozzle is set to far away from the bed, causing it to fail and drag the printed plastic to move around and be dragged by the nozzle.

The first thing you will need to do is level the bed to the nozzle.

This is where you move the nozzle (cleaned and cool) to just above the small sprung screws and adjust/tighten/loosen the screws so that the gap between the bed and the nozzle is small enough that a sheet of paper can just fit in between (with some resistance)

This will mean your plastic coming from the nozzle will be flattened into the glue (assume its magigoo or a purple elmers glue type thing?) and will stick.

Have you looked at bed levelling when you started? - just incase this can be ruled out