Spinza V1/2 Chassis

[PJ-27]

I'm becoming terrible for hoarding robot spares that I'll likely never use, so if anyone's interested in the following Spinza parts let me know.

I'm re-building Spinza for V3 because I was unimpressed with the performance of past ones.

IMG_3267.jpg

Not included:
Drive ESC
Weapon ESC or Motor
Hex adaptors for Banebot wheels (in picture but not included)
Battery

Included:
Laser cut parts and jigs (loads spare)
Spare Polycarb panels
5/10mm Polycarb chassis (big crack on lower bulkhead)
3mm thick, 200mm long Stainless Steel bar (with bolting pattern)
12T 2.5pitch Pulley (piloted out to 3mm)
40T 2.5pitch Pulley with fitted pulley (not pictured) bolts onto bar
8mm silver steel weapon shaft (ends tapped to M5)
Spare weapon shaft (untapped)
2.5Pitch Tming belt
3mm Eurethane belt (various lengths and spare to be made up)
Smooth pulleys for the belt
2 x 8mm ID Thrust bearings (for weapon)
2 x nylon spacers for weapon bar
1 x Micro Orange RX (brand new)
2 x 75mm Banebot wheels
2 x 30:1 24v MFA motor/gearboxes/mounts
Complete wiring loom (Link, fuse, light, female bullets for weapon and soldered ends for drive, deans battery connector)

Questions, offers etc give me a shout (best to get me on Facebook) happy to post anywhere UK mainland.

[PJ-27]

Sold