A bit of a controversial topic I know but I went with the Cytron dual 60A speed controller on the notion that it can be retrofitted with passive cooling rather than active cooling. Definitely looks as if it can, the fans sit on their own platform which can be disassembled so I'll be getting some thermal paste and chipset passive coolers to add onto the controller.
I had a chance yesterday to roughly position where the drive system stuff is going to go on the 10mm polycarbonate board I got a few weeks ago. I had also bought a set of Nylon 6 HS crossmembers for The Honey Badger ages ago but decided to hold it off for this. Certainly feels like a Heavyweight at the moment. :P About 800mm wide by 430mm long at the moment.
DSCF6127.JPG
The big issue I have at the moment is finding wheels that attach onto the motors. I am sure there are some out there that fit onto these MY1020 (or MY1016, not sure) threads but I can't seem to locate any. Anyone know of any? I think the threaded part of the shaft is 9 or 10mm wide.
Bookmarks