Came back today, immediately set to it. Cut out the holes for the wheels with the Dremel. However, without a speed controller, I can't really complete the wiring. LED power light has been wired into a plug and the lifting servo tested, plenty of torque in it.

I also need to figure out how to mount the motors. The cutting has left the centre back section a tad weak but I can mount the motors in the corners where there is still strength.

From left to right:


  • The shell with the wheel cutouts made.
  • The shell with the motors and wheels roughly (and I mean roughly) located in the shell
  • The motors wired up with perhaps the neatest soldering I have done in ages


DSCF5642.JPGDSCF5643.JPGDSCF5644.JPG