Wheels for a cordless drill gear motor | Any suggestions?

[lowndsy]

When I was still on drill motors I found these wheels

http://www.screwfix.com/p/select-rub...diameter/8359p

Work well with this nut:

http://www.ebay.co.uk/itm/3711183674...%3AMEBIDX%3AIT (think I went for "long female")

The hole is a bit smaller than the nut but I didn't drill it out - I jigsawed some little guidelines matching the corner points of the nut, flooded the hole with hot glue and then hammered the nut in nice and snug.

The L/H screw goes through the narrower hole at the end to tie it together nicely. After reading that same Australian guide I made sure the hole in the washer wasn't too loose. I also hacked off the little neck on the rear so the motor fits closer to the body of the wheel.

Then I got fed up trying to mount the motors and bought some Gimsons.