Where did you get those gears and motors from? Seems extremely compact, that kind of setup for drive!
Where did you get those gears and motors from? Seems extremely compact, that kind of setup for drive!
Lol, but you aren't building that one are you! I admit Rango looks nothing in comparison but it'll probably cost a 3rd to build lol.
The motors are now discontinued/out of stock it would seem. They were originally from here: http://www.pollin.de/shop/dt/Mjk0OTg...HC885G_AS.html
The right angle gears are for cheap 4" angle grinders. Got a set of 3 on ebay from China for 12 quid delivered :P. They're pretty rough in truth, both in finish and meshing, but I popped open the kind of grinder they go in a while ago and they were worn in and smooth running. The belts and pulleys are all from www.beltingonline.com.
Its getting harder to source decent sized brushed motors. Noticed that these are still up for sale http://www.ebay.co.uk/itm/2009126068...84.m1423.l2649
Bulkheads are now being machined, I'm soon going to order a Spektrum dx6i and a 5s Optipower LiPo. Once that's done I'm going to go across to the workshop and start making anything I can to make assembly once the bulkheads arrive that little bit faster. Ball is gradually getting rolling, sadly it's now less than two months until the champs!
Mounting plate, standoffs and shaft support. The bearing will sit into the bulkhead this lot bolts to.
Very \m/etal mount mate. You pumped this out quick.
Grab 'em while you can!
http://www.ebay.de/itm/Graupner-Spee...item417cbe3621
mm - saying shipment to Germany only
Also this
http://www.ebay.co.uk/itm/GRAUPNER-S...item5d4963f67b
I wouldn't buy that, £36 for the motor, £11 for postage and £12 import charge.
The progress in your build skill Ellis just gets better and better!
How did you make the brushless plate?
Bookmarks