Say, Peter, where do you get the track sytems for ur ants?
Say, Peter, where do you get the track sytems for ur ants?
They are Tamiya (TAM70100) which gives you various cogs and tension pullies plus a selection of different lenth tracks that can be connected together.
I bought the last lot from here as they are cheap but you can get them in the UK.
http://www.buy-model.com/itemdetail.php?Id=862&FormZoneId=204&ShippingType= Surfacehttp://www.buy-model.com/itemdetail....pingType=Surfa ce
Some other Tamiya sets have motor and gearboxes included but they obviously cost more.
I then add some of the sticky rubber on the outside to improve the grip.
Oh, ok.
Just wanted to know incase i wanted a tracked ant.
It says on the page linked to the tracks that they weigh 485g, surely the antweight limit is 150g?
Thats for a large set of them. He cuts them up into antweight size sections which will fit in the limit
( :-\
Anyone got any experience in overvolting the HPX servos using a two cell lipo?
Do they just go faster or do they start smoking like the HS81
Andy
Ive been using 8.4V in Flippt! for ages, and amazinly it still works.
It will both go faster and stronger.
However, you should beware of that you are, like most motors etc., cutting down on the lifespan for it.
Ive been using the HPXF servo with a 2 cell lipo for a while, as has Marco, and the worst Ive done was stripped a gear (Although I did get smoke off the motor in one due to the pot being in the wrong place and full power being on after putting the gearbox back together wrong)
Bookmarks