Neon Lights?

[s8nsmum]

In my new featherweight i am planning to use neon lights to create a glow from underneath. The problem is that the tubes run on 160V, there is a tiny circuit board supplied with them to up the 12v input to 160-180V. Are these allowed? or am i breaking the maximum allowable voltage rule?

Joseph Townsend

[jim]

I wouldnt feel comfortable picking up a damaged robot that I knew could generate 160V. That should be common sense, not something you should consult the rules about.

Can you use blue or white LEDs to create a similar effect?

[babeth]

Neon lights ? Those things that shatter and splinter at the least impact ? Not where I am present thank you very much !!!

Better stick with LEDs, they use a lot less power and are very sturdy. You would be amazed at the amount of light a couple of LEDs can generate with practically no power at all. (I use a string of those in my little Christmas tree, runs an entire week, 24h/24h, on two AA batteries.)

[stu]

Have to say mate, even tho it will be low current, 160v shock will not be nice. I would think you are breaking the over 36 (or evne the new 60v rule) full stop.
We all know that its not giving you any advantage in terms of fighting power (well it might if it goes to a crowd vote- hehe) and in terms of damage, i dont think there practical. Like babs said, shatter and all sorts sadly.

My 2 pence worth.
Mr Stu

[geoff]

Joseph,
I think I will have to side with Stu and Ms Van Son on this one.I feel 160V would be a clear breach of the rules (Personaly I wouldnt go near it in the arena). You will defenatly do better with some ultra bright LEDs.Try Maplin and/or RS Components, and of course, with LEDs not only will you save a serious amount of both battery life and weight you also have a choice of colours!
Geoff,
Team Scorpion

[babeth]

Hmmm... now that I think about lights... my old robot Project Two: Hexem (Dutch Wars 2002/2003) has two eyes who shine red. It is two 50W halogenic lights on one 2 Amp/h 12 Volt Phoebus battery behind red polycarbonate. Beautiful special effect. Another Dutch robot, X-Bot (Dutch Wars 2001), had a halogenic spot light on both sides built into the robot, was nice too.

It doesnt have to be neon in order to be flashy !!!

Also note that Tough As Nails (which we helped build) has 2 red High Density LEDs to mark weapon activation and a normal red LED to mark robot active, there has also been a blue LED to mark weapon solenoid powered but is has been removed and not yet replaced. With the new FRA rules demanding visible signs of activation you might consider installing that as well if you want to go on the live circuit.

[s8nsmum]

ok, i think that is a definate no. The neons i was thinking of using were flexible wires rather than glass tubes so there was no chance of them smashing. The only low voltage ones i could find are glass which is why i wanted to know if i could get away with the bendy ones. So unless anyone knows where i can get hold of some low voltage bendy neons i am going to have to go with LEDs

Thanks,

Joseph Townsend

[leorcc]

people have made flashlights with LEDs, so to create a 2 fast 2 furious like glow you can use blue LEDs.

I know the type of flexible wires you are referring to, was looking at using them myself on one of my bots. I missed the part of them being 160V though.